aJ5dY4aD9y
Do³±czy³: 09 Maj 2014
Posty: 86
|
 Wys³any:
Pi± Maj 09, 2014 08:27 |
  |
dmjs.runInlineAd = true; $('.AdUnit160').hide(); $('.AdWrapper').addClass('no160'); ; googletag.cmd.push(function() googletag.display('160x600') ; Instructions 1 Lay the foam on a flat, dry surface. Measure out the components of the airplane and sketch them onto the foam with the pencil. The wings are 36-by-7 inches. The fuselage is 24-by-6 inches wide, and the tail structure is 5 inches square. 2 Cut out each piece with the hacksaw, and sand slightly until the edges are smooth. Once the wings are cut out, measure an area on the end of each that is 3-by-7 inches. These will be the ailerons. [url=http://www.goldvk.com/Game.gw2_us.Guild Wars 2.gw2.Gold.Info.aspx]gw2 gold[/url] Cut them out of the wings. dmjs.revenueTags.push('ca-ehow_300x250;game_hobbies,text,suggested7'); googleAds.addAdUnit( priority : 3, adUnitId : 'GoogleAdsense300x250', google_ad_channel : 'game_hobbies,text,suggested7', google_ad_client : 'ca-ehow_300x250', google_max_num_ads : '1', google_ad_type: 'text', templates: { text : ' \ Sponsored Links {! for (var i = 0; i \ \ {!= ads[i].line1 ! \ \ != ads[i].line2 ! != ads[i].line3 ! != ads[i]. [url=http://www.goldvk.com/Game.gw2_us.Guild Wars 2.gw2.Gold.Info.aspx]guild wars 2 gold[/url] visible_url ! \ \ \ ! ); 3 Attach the ailerons to the wings with packing tape. Create a hinge out of the tape by folding each piece over with the sticky side out. The ailerons need to move to control the plane. 4 Epoxy the wings and the tail structure to the fuselage. The wings should be placed flat approximately near the center of the body. Glue the tail to the rear end of the fuselage. Rather than placing it flat like the wings, the thin edge needs to be placed down the center of the fuselage so that the piece sticks up in the air in line with the body of the plane. 5 Mount the motor and the fuel tank on the nose of the airplane with epoxy. Epoxy one servo on the tail, one on each of the ailerons, and one in the front near the engine. Cut the Velcro into small strips with the scissors, and Velcro the receiver near the engine. [url=http://www.goldvk.com/Game.gw2_us.Guild Wars 2.gw2.Gold.Info.aspx]gw2 gold[/url] Connect the wires to the receiver, and the receiver to the motor. Connect the battery to the receiver. Attach the propeller to the engine and screw on by hand until snug. xboter 2014 |
|
|
